sIMPLEk Stick for Yamaha
Availability: In stock
sIMPLEk Stick for Yamaha
First dongle with correct speed indication on the display.
sIMPLEk Stick for Yamaha – The first tuning dongle with correct km/h display
The sIMPLEk Stick is a tuning dongle that completely takes away the 25 km/h speed limitation of E Bikes with Yamaha drive systems. Thanks to this tuning tool you can drive much faster with full engine support - theoretically even up to 100 km/h. Thanks to the supplied connection cable, you can attach the sIMPLEk Stick anywhere at your E Bike, for example to the handlebars – this enables you to switch the tuning on or off at any time by plugging or unplugging the dongle.
We would like to point out that the sIMPLEk Stick is a kit which you first have to assemble yourself. But the assembly is very simple. However, it should be mentioned that the supplied USB plug must be connected to the board using a soldering iron.
A special feature of the sIMPLEk Stick is that it is the first tuning dongle where - despite activated tuning - the correct speed can still be read in the E Bike display. Up to 10 km/h the speed is shown 1:1. Above 10 km/h the speed is indicated via the second digit and the decimal place.
5.6 km/h –> 5,6 km/h
10.0 km/h –> 10 km/h
10.5 km/h –> 5 km/h
13.5 km/h –> 35 km/h
Maximum speed and distance travelled (total distance) are also displayed correctly (but only after a little over 1 minute at standstill).
Hint: In order to be able to read the actual speed for each wheel circumference with activated tuning, a one-time calibration must be carried out the first time the sIMPLEk Stick is used.
The sIMPLEk Stick Yamaha has 2 operating modes:
1) Tuning mode (unlimited support, theoretically up to 100 km/h)
2) Calibration mode
sIMPLEk Stick forYamaha - Compatibility
-Yamaha E Bikes (PW, PW-SE, PW-X, GIANT SyncDrive).
The sIMPLEk Stick is made in Germany.
The sIMPLEk Stick for Yamaha is delivered as a kit consisting of 4 parts (board, USB plug, connection cable, housing). Since the board is already equipped with the SMD components, however, the assembly is extremely simple. Just solder the USB connector to the board. Afterwards you only have to insert the board into the USB case and the dongle is completely assembled.
Now you have to open the motor cover and connect the connection cable of the sIMPLEk Stick to the original sensor (sIMPLEk must be connected between motor and speed sensor). Use the USB connection cable and the supplied cable ties to attach the sIMPLEk Stick to your E Bike at a position of your choice – we recommend directly on the handlebars. This enables you to easily connect or remove the stick at any time.
You can find a detailed assembly instruction and installation guide right “HERE”.
Legal information: For legal reasons, the sIMPLEk Stick for Yamaha E Bikes may not be used on public roads or within the scope of the road traffic regulations (this also applies to all other E Bike tuning tools). The sIMPLEk Stick may only be used on private ground, e.g. for competition or test purposes. Use of the tuning tool may void the warranty of your Yamaha electric bike. No liability is assumed for any current or future damage (direct or indirect) arising from the use of the sIMPLEk Stick. You have to use the device at your own risk. We also assume no responsibility or liability for any damage that may occur during assembly or soldering of the sIMPLEk Stick.