siMPLEk Pro for Impulse

This tuning module completely removes the 25 km/h (or 45 km/h) speed limitation of your Impulse E Bike drive system, so that you can finally enjoy the full motor power of your system.
SKU: simplek-pro-impulse

Availability: In stock

€139.90
Incl. 19% Tax
Product Description
Details

siMPLEk Pro for Impulse

This tuning module completely removes the 25 km/h (or 45 km/h) speed limitation of your Impulse E Bike drive system, so that you can finally enjoy the full motor power of your system. This tool has no other functions.

The installation of the tuning module at the engine is relatively simple (depending on the E Bike manufacturer) - in principle only one plug has to be pulled at the engine and the sIMPLEk module has to be interposed (see below). After installation, the sIMPLEk Pro tool is not visible from the outside.

In the default configuration, the tuning is always disabled when you turn on your E Bike. To activate the tuning, simply switch off the E Bike immediately after starting, wait five seconds and switch it on again. A 10 km/h speedometer display indicates that the tuning has been activated.

Made in Germany.

Important note: This sIMPLEk module for Impulse is the "Pro" version - this means that the tool is supplied as a finished product. You do not need to assemble it yourself.

Current speed remains readable

Unlike some other E Bike tuning tools, the actual tempo remains visible on the speed display when you use the sIMPLEk Pro tuning module - however, via the second digit and the first decimal place of the display. An example: A displayed speed of 14.1 km/h would correspond to a real speed of 41 km/h, etc.

Even values such as maximum speed and mileage / total distance are displayed correctly - but please note that these values are only adjusted after approx. 1 minute at standstill.

sIMPLEk Pro for Impulse - Compatibility

All E Bikes with the following Impulse drive systems: 2.0 / EVO / EVO-RS

Simple Installation

The installation of the sIMPLEk Pro module is simple and can even be carried out by technically inexperienced laymen themselves. Please note, however, that the disassembly work required to get to the speed sensor connector may vary depending on the E Bike manufacturer. If the motor is integrated into the frame at the head end, access to the cable harness can often be achieved without any disassembly work. If this is not the case, you must remove the motor to install the sIMPLEk Pro.

Always remove the E Bike battery before installing sIMPLEk. The sIMPLEk Pro must be plugged between the speed sensor connector. For more detailed information, please see the operating instructions.

After the initial installation, a one-time calibration must be performed so that the correct speed can be read in the speed display if the tuning is activated.

Additional Information
Additional Information
Manufacturer sIMPLEk
Reviews
Write Your Own Review

Only registered users can write reviews. Please, log in or register