sIMPLEk Pro for Bafang
Availability: In stock
sIMPLEk Pro for Bafang
The sIMPLEk tuning module as a practical ready-to-use product. sIMPLEk Pro is an affordable tuning tool that completely removes the 25 km/h (or 45 km/h) speed limitation of E Bikes with Bafang “Max Drive” motors - allowing you to finally use the full potential of your drive system. In contrast to some other tuning modules, the real speed remains readable on the E Bike display if you use sIMPLEk Pro (see below for more detailed information).
In contrast to the conventional "sIMPLEk kit for Bafang" you don't have to put the "sIMPLEk Pro" together at first - the "Pro" version is always delivered as a finished product. Since sIMPLEk Pro is a tuning module, it has to be installed in the motor housing of your Bafang drive system. To get access to the required connectors you have to remove the crank of your Bafang E Bike and the motor cover. Disconnect the speed sensor plug and connect the sIMPLEk module between the motor and the speed sensor. Then all you need to do is reattach the engine cover and the crank - and the installation is complete. After that, the tuning module is not visible from the outside.
Detailed installation instructions can be found "here" (LINK zu https://www.simplek.de/sIMPLEk_Bedienungsanleitung_Bafang.pdf).
Tuning mode can be switched on or off
In contrast to some other E Bike tuning modules, the tuning mode is not permanently activated when you use sIMPLEk Pro. If you switch on your E Bike, the tuning mode is always deactivated and your E Bike works as usual = with speed limitation. If you want to activate the tuning, simply switch the E Bike off and on again within 10 seconds after starting. In order to indicate that the tuning is active, the speedometer will then display a speed of 10 km/h at standstill. Now the tuning mode is activated and the maximum motor support reaches - theoretically - up to 100 km/h.
Real speed remains readable
With some E Bike tuning modules there is the problem that the correct speed is no longer shown on the E Bike display when the tuning is active. This problem does not exist with the sIMPLEk Pro. Even when tuning is active, the real speed remains visible, but only via the second digit and the decimal place of the display. Here are a few examples:
- Speed shown in the display
- Real speed
- 10.6 km/h
- 6 km/h
- 13.8 km/h
- 38 km/h
Also other values such as total kilometres and maximum speed are displayed correctly, but these data are only adjusted after approx. 1 minute at standstill.
The sIMPLEk Pro tuning module is made in Germany.
sIMPLEk Pro for Bafang - Compatibility
Bafang „Max Drive“ mid-mounted engines for electric bicycles.