sIMPLEk assembly kit for Bafang

The tuning module for handicraft enthusiasts. After the installation sIMPLEk lifts the 25 km/h or 45 km/h speed limit completely, so that you can finally use the full power of your Bafang drive system.
SKU: simplek-assembly-kit-bafang

Availability: In stock

€79.90
Incl. 16% Tax
Product Description
Details

sIMPLEk assembly kit for Bafang

The tuning module for handicraft enthusiasts. This sIMPLEk assembly kit is a very low-priced tuning module especially for E Bikes with Bafang Max Drive motors. After the installation sIMPLEk lifts the 25 km/h or 45 km/h speed limit completely, so that you can finally use the full power of your Bafang drive system.

When the E Bike is switched on, the tuning is initially deactivated (1:1 mode, the E Bike functions as in its original condition). You can easily activate the tuning by switching off and restarting the E Bike within 10 seconds. Then the tuning mode is activated and the speedometer shows 10.0 km/h at standstill.

The real speed remains readable even in the tuning mode - however via the second digit and the decimal place of the speed display. An example: If the tuning mode is active, a speed display of 13.5 km/h would in fact correspond to a speed of 35 km/h.

The maximum speed reached and the distance/total distance covered are displayed correctly, even though only after approx. 1 minute at standstill.

Please note: This sIMPLEk module is supplied in the form of a kit, which you must assemble yourself before installation. The kit consists of only five components (board, microcontroller, capacitor, diode, industrial plug/pin plug), but when assembling the module you have to solder single elements together. To connect the assembled sIMPLEk module to the E Bike, you must remove its crank and motor cover. Then simply connect sIMPLEk between the motor and the speed sensor. After installation, the sIMPLEk module is not visible from the outside.

When assembling the sIMPLEk module you can optionally bridge the connection "J1" on the circuit board so that the tuning mode is always active when the E bike is switched on - in this case the 1:1 mode is permanently deactivated.

Detailed installation instructions can be found "here" (LINK to https://www.simplek.de/sIMPLEk_Bedienungsanleitung_Bafang.pdf).

Made in Germany.

Tip: The sIMPLEk assembly kit for Bafang engines is also available in a finished version, the so-called “Pro” version. This module is delivered as a finished product and does not have to be assembled before installation.



sIMPLEk assembly kit for Bafang – Compatibility

Bafang Max Drive mid-mounted engines for E Bikes

Additional Information
Additional Information
Manufacturer sIMPLEk
Reviews
Write Your Own Review

Only registered users can write reviews. Please, log in or register