BadassBox 3.4 for Conti
The badassBox 3.4 is an approved electric bike tunin..
Availability: In stock
BadassBox 3.4 for Conti Electric Bike Engines
The badassBox 3.4 is an approved electric bike tuning tool which takes away the 25 km/h speed limit and shifts it up to 50 km/h. This means, you can drive twice as fast with full engine support. The Badassebikes Chiptuning Box 3.4 (=badassBox 3.4) works with Bosch, Yamaha, Kalkhoff/Impulse, Brose and Shimano electric bike systems – and now it is compatible with Conti respectively Continental electric bike engines, too!
This tuning device is very easy to handle and can be installed within a few seconds. Simply connect it to the speed sensor of your Conti engine and secure it with a rubber ring. Reposition the magnet on the bicycle spoke. After that is done, the Box will halve the transmitted speed when you reach a speed of approx. 18 km/h. Now the engine support won´t stop at 25 km/h anymore and you can drive up to 50 km/h with full support. The microprocessor of the badassBox switches on and off automatically. It has no electrical contact with the system.
Important: If the tuning is active, your electric bike display will only show half of the real speed. This means: If your display shows a speed of, for example, "20 km/h", your real speed is 40 km/h and so on.
The power supply comes from a battery which provides an operational distance of about 6.000 km or one year (discharged battery), thanks to low-power-technology.
In comparison with the previous versions of the Chiptuning Box, the new badassBox 3.4 has been greatly improved. The housing of the Box has been strengthened, the electronics enhanced and the firmware is better adapted to the respective engines of the various electric bike manufacturers. The new badassBox Type3.4 is absolutely splash proof and less sensitive to vibrations and bumps. In short, this amazing tuning device is better than ever!
Please note: It is not allowed to use the BadassBox on public roads. But that is no real problem, because the Box can be removed very quickly. After it is pulled off and the magnet is shifted back to its original position, your electric bike is back in its original condition and you can drive it legally on public roads again. The size of the device is similar to a matchbox – you can simply stow it away in your trouser pocket and take it with you.
Where is the correct Position for the Magnet if I use the BadassBox?
Maybe you ask yourself about the correct position of the magnet on the bicycle spoke if you use the badassBox to tune your electric bike. Unfortunately, it is not possible to tell you a generally valid position, because there can be great differences from one electric bike to another.
If you got problems with the positioning of the magnet, we recommend the following procedure:
- Plug the Box into the speed sensor of your electric bike and fix it with a rubber ring. Important: Try to position the magnets front surface upwards or downwards.
- Place the magnet approx. 2 cm behind the box towards the wheel centre.
- Rotate the wheel at least five times (or more) and check out if the display indicates the speed. Important: You have to rotate the wheel at least five times; otherwise the Box has no ample opportunity to awake from a possible Standby mode.
- If the display shows no speed, slide the magnet 2 mm further towards the Chiptuning Box.
- If a speed is shown, you can slide the magnet 1 mm further towards the Box.
- Now the magnet has the correct position on the bicycle spoke.
If you execute this procedure, the correct positioning of the magnet should be no problem anymore. We hope this information was helpful for you.
Please note: Li-Ion batteries (size: CR2) are not included.