MBIQ-S Tuning Sensor - Yamaha / Giant / AEG
Availability: In stock
MBIQ-S tuning sensor for Yamaha / Giant / AEG
A microcontroller based tuning solution for E-Bikes with Yamaha / Giant and AEG drive systems. After installation, the tuning tool removes the 25 km/h speed limitation, allowing you to ride much faster with full engine support. This is what makes E-Bike riding fun!
Since this tool is a ready-to-use sensor solution, installation is extremely simple. Basically, you just have to replace the original sensor with the tuning sensor (thanks to original plug connectors, an optimal connection is ensured). Due to the highly integrated electronics, the tuning tool is very compact and hardly requires any installation space. Simply keep the original sensor in case you want to restore the original condition of your E-Bike at some point.
The MBIQ-S is completely maintenance-free and does not require its own battery.
As the tuning sensor looks very similar to the original sensor, the appearance of the E-Bike is not affected.
How it works
After installation, the tuning sensor analyses the current speed profile and transmits manipulated values. With tuning switched on, speeds above 25 km/h are blocked for the engine firmware, thus removing the 25 km/h speed limit.
Please note: Due to this operating principle, the displayed speed will always remain ≤ 25 km/h. Therefore, if the speed exceeds 25 km/h, the correct speed is no longer displayed.
Three operating modes
With the MBIQ-S you have the possibility to set three different operating modes through specific, sequential wheel movements.
- Tuning is permanently activated (speed limitation removed).
- Normal operation mode (here the tuning sensor behaves like the original, "passive" sensor / motor support up to 25 km/h).
- Tuning mode selectable at start (here you can decide if the tuning should be ON or OFF when switching on the E-Bike: To switch the tuning on, the magnet must be in front of the sensor for about 4-5 seconds when the system starts).
MBIQ-S Tuning Sensor for Yamaha / Giant / AEG – Compatibility
This tuning tool is compatible with the following E-Bike engines:
Yamaha (PW / PW-SE / PW-X), Giant (SyncDrive Life / SyncDrive Sport / SyncDrive Pro), AEG (Drive)...and other systems, as long as they are equipped with a suitable plug.
Important note: For AEG / GIANT please check the connector for compatibility in advance!
Scope of delivery
- MBIG-S tuning-kit sensor cable (cable length approx. 60-65 cm)