MBIQ-S Tuning Sensor for Bosch E Bikes

Here we have a simple but efficient tuning tool for E Bikes with Bosch engines. MBIQ-S is a microcontroller-based sensor solution that completely removes the speed limitation of Bosch drive systems. There are no further functions.
SKU: mbiq-s-bosch

Availability: In stock

€119.00
Incl. 19% Tax
Product Description
Details

MBIQ-S tuning sensor for Bosch E Bikes

Here we have a simple but efficient tuning tool for E Bikes with Bosch engines. MBIQ-S is a microcontroller-based sensor solution that completely removes the speed limitation of Bosch drive systems. There are no further functions. A big advantage is the very easy installation, because you just have to replace the original sensor with the MBIQ-S.

The MBIQ-S tuning tool does not require a separate battery.

How it works

After connecting the MBIQ-S, the tool will analyze the current speed profile and, if the tuning is active, transmit manipulated values to the motor firmware. This will lock speeds above 25 km/h for the motor firmware, so that the 25 km/h speed limit of Bosch E Bike motors is completely removed. Please note: As a result of this functional principle the speedometer will no longer show the correct speed (with active tuning the displayed speed will always remain ≤ 25 km/h).

Note: The analysis of the motor software is not affected by the manipulated values.

Three operating modes:

With the MBIQ-S tuning tool you have the possibility to program three different operating modes via specific, sequential wheel movements:

  1. Tuning permanently activated (no limitation of the motor support, from approx. 25 km/h the displayed speed does not correspond to the real speed anymore).
  2. Tuning permanently deactivated (motor support up to 25 km/h, real speed is displayed).
  3. Tuning activation via switch-on condition: To activate the tuning, the magnet must be in front of the sensor for about 3-4 seconds during startup, otherwise the tuning is deactivated

Easy  installation

For installation, you simply need to replace the original sensor at the bike´s rear frame with the MBIQ-S. As the tool is equipped with original connectors, an optimal connection is ensured.

Please note: As the plug end is plugged into the engine compartment, in most cases the left crank arm must be removed. Special tools are required for this. Under certain circumstances it may also be necessary to remove the plastic cover of the engine.

Thanks to its neutral appearance, the installation of the tuning tool will not change the appearance of your electric bicycle.

Tip: We recommend that you keep the original sensor if you ever want to restore the original condition of your Bosch E Bike.

You can find detailed installation- and operating-instructions "Here".


Robust & insensitive to moisture

As the electronics of the MBIQ-S are encapsulated in the sensor, the tool is resistant to water and dirt.


MBIQ-S tuning sensor – Compatibility

Compatible to the following Bosch drive systems: Active Line, Active Line Plus, Performance Line, Performance Line CX. It works with all common motor firmware.


Scope of delivery

  • MBTK-S tuning-kit sensor cable with original connectors (cable length approx. 60 cm)
  • Instructions

 

Additional Information
Additional Information
Manufacturer Yeollin
Reviews
Write Your Own Review

Only registered users can write reviews. Please, log in or register