sIMPLEk Stick for Bosch Gen2
Availability: In stock
sIMPLEk Stick for Bosch – A tuning dongle with correct speed display
The sIMPLEk Stick is a tuning dongle to completely eliminate the 25 km/h speed limitation of Bosch E Bikes. This allows you to ride much faster with full engine support.
Please note that the sIMPLEk Stick is a dongle you have to assemble yourself. When assembling, a soldering iron must be used to connect the supplied USB plug to the board. However, the assembly is very simple, so that even technical laymen should have no problems. Thanks to the supplied connecting cable, you can attach the stick to the E Bike in a position of your choice - preferably directly to the handlebars.
To activate the tuning mode, simply plug in the sIMPLEk Stick (after the wiring has been installed) and the 25 km/h speed limitation of the engine support will be removed. Even when the tuning is activated, the correct speed can still be read:
Up to 10 km/h the speed is displayed 1:1. Above 10 km/h it is indicated by the second digit and the decimal place.
5.6 km/h –> 5,6 km/h
10.0 km/h –> 10 km/h
10.5 km/h –> 5 km/h
13.5 km/h –> 35 km/h
Maximum speed and distance travelled / total distance are also indicated correctly (but only after a little over 1 minute at a standstill).
Note: To ensure that the actual speed can be read for each wheel circumference in the tuning mode, a one-time calibration must be carried out when using the stick for the first time.
The sIMPLEk Stick thus has 2 operating modes:
1) Tuning mode (unlimited support, theoretically up to 100 km/h)
2) Calibration mode
sIMPLEk Stick for Bosch - Compatibility
-Bosch (Classic Line, Active Line, Performance Line, Performance Line CX).
The sIMPLEk Stick is Made in Germany.
As already mentioned, the sIMPLEk Stick is delivered in the form of a kit, which only consists of 4 components: circuit board, connecting cable, USB plug and housing. Since the board is already equipped with the SMD components in the delivery condition, the assembly is absolutely simple. All you have to do is to insert and solder the USB plug. After that, the circuit board only has to be inserted into the housing.
Then the connecting cable of the sIMPLEk stick must be connected in front of the original sensor of the electric bike. First the crank has to be removed and the motor cover has to be opened, which requires additional tools. The sIMPLEk Stick can be attached to a position of your choice, e.g. directly on the handlebars, using the connecting cable and the cable ties supplied. So you can easily connect or remove the stick at any time.
You can find a detailed assembly and installation manual "HERE" .