With the MTT a new, outstanding software tuning product is launched on the market! The MountainTuning tool (MTT) optimizes Rocky Mountain Altitude Powerplay motors – you can set the maximum engine support from 0-99 km/h. In addition, the current strength can be increased from 20 to 22 A – this means you benefit from 10% more power (1056 watts peak wattage output) ! The MTT can also be removed after use or used instead of the iWoc controller. The current speed is shown on the display when the device is in use. Due to its extensive functions the MountainTuning tool is one of the most comprehensive E Bike software tuning products on the market.
In addition to the display function, you can use the MountainTuning tool to make the following changes in the drive system´s settings:
A) Adjust the maximum motor support (from 0 to theoretically 99 km/h),
B) Increase the amperage (from 0 stepwise up to 20 A and over 21 up to 22 A),
C) Set the wheel circumference to the millimetre or
D) Change the display from km/h to mph.
The new update (September 2018) contains these new additional features:
E) 50 percent more motor support (torque) for even stronger acceleration.
F) Calibration via MTT.
G) Automatic switch-off after 10 minutes of inactivity.
H) The display now shows a temperature display in the upper left corner.
The MountainTuning Tool (MTT) is exclusively available in our shop. If you have an older MTT, then you can buy an “Update”.